Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 95
#1

Hi Guy's,
Posted a thread before about a model 95 I brought home last week.
Aaron was correct about the cabinet being refinished. After looking it over closely and comparing to an original 95, I can see it now.
Probably won't refinish it though as I am going to sell it anyway.
The radio plays perfectly, but of course I had to remove the chassis and the bottom cover plate just to see if it has ever been re-capped.
Kind of a strange layout as compared to what I usually work on.
Appears to be unmolested.
Caps are held in with brackets or clips and some are wired to the side of the cap.
Resistors all appear to be original.
I am amazed that this still plays like a new radio with as old as it is.
Looking at Nostalgia radio schematics, I do not see a parts list.
Don't see that the caps are marked either.
One page of the schematics does show part ID numbers on the caps.
Anyone have a parts list for this radio?
murf
#2

http://www.philcoradio.com/tech/images/95.jpg
Note a few of the caps have resistors molded in with cap. Easiest way to repair is to cut the gnd lead off and solder new cap under the old one.
Terry




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5328 online users. [Complete List]
» 1 Member(s) | 5327 Guest(s)
Avatar

>