1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Voltage on the chassis Philco 38-8
Stan the Man
Member
***
Posts: 62
Threads: 10
Joined: Nov 2015
City: Memphis,Tn
#22

03-20-2016, 04:10 PM
Everything back in its place, shows 55volts.. My meter shows no current.. I'm sure there is something there, my meter just won't show it.. interestingly though, that hum got worse.. I took a small screw driver and probed around until i found what changed the hum..
Originally I had to replace the bias resistor with a terminal strip and resistors.. the screw that was holding the strip, and make up the ground was loose..
Tightening that screw killed the hum..
(This post was last modified: 03-20-2016, 04:12 PM by Stan the Man.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-17-2016, 02:53 PM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-18-2016, 09:10 AM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-18-2016, 10:09 AM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-18-2016, 08:37 PM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-18-2016, 10:45 PM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-19-2016, 09:00 AM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-20-2016, 09:08 AM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-20-2016, 01:00 PM
RE: Voltage on the chassis Philco 38-8 - by Stan the Man - 03-20-2016, 04:10 PM
RE: Voltage on the chassis Philco 38-8 - by morzh - 03-20-2016, 08:05 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration