02-07-2010, 04:45 PM
So think back 40 years ago. If you have a 1000-2000 ohm per volt meter, and the plate on the detector has a 2.5 meg resistor, sure you are going to have a low value when you attempt to measure it.
|
Philco 90: expecting too much?
« Next Oldest | Next Newest »
Messages In This Thread
Philco 90: expecting too much? - by Guest - 02-05-2010, 12:28 AM
Re: Philco 90: expecting too much? - by Ron Ramirez - 02-05-2010, 06:49 PM
Re: Philco 90: expecting too much? - by Guest - 02-05-2010, 07:41 PM
Re: Philco 90: expecting too much? - by Ron Ramirez - 02-05-2010, 09:57 PM
Re: Philco 90: expecting too much? - by Guest - 02-06-2010, 10:34 PM
Re: Philco 90: expecting too much? - by exray - 02-07-2010, 08:48 AM
Re: Philco 90: expecting too much? - by Ron Ramirez - 02-07-2010, 11:42 AM
Re: Philco 90: expecting too much? - by 7estatdef - 02-07-2010, 03:01 PM
Re: Philco 90: expecting too much? - by 7estatdef - 02-07-2010, 03:19 PM
Re: Philco 90: expecting too much? - by 7estatdef - 02-07-2010, 04:07 PM
Re: Philco 90: expecting too much? - by codefox1 - 02-07-2010, 04:45 PM
Re: Philco 90: expecting too much? - by Guest - 02-07-2010, 11:27 PM
Re: Philco 90: expecting too much? - by 7estatdef - 02-08-2010, 07:59 AM
Re: Philco 90: expecting too much? - by codefox1 - 02-09-2010, 05:31 PM
Re: Philco 90: expecting too much? - by Ron Ramirez - 02-15-2010, 10:09 AM
Users browsing this thread: 1 Guest(s) |
