Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Question regarding capacitors
#18

(03-10-2018, 09:34 PM)Phlogiston Wrote:  Yep, in later radios or those with values over about 20uf we are still stuck with electrolytics. You know there is a series of Nichon caps that are about as thin as a pencil. you can easily get 3 or more in an old can.

Thanks for the info. I did use the thin caps in 3 of my Z Transoceanics. Restuffing the cans was a must on these radios, as room was limited and I didn’t want to start making a mess by adding terminal strips etc.

Tony

“People may not remember how fast you did a job, but they will remember how well you did it”


Messages In This Thread
Question regarding capacitors - by Ron Ramirez - 03-06-2018, 09:10 PM
RE: Question regarding capacitors - by morzh - 03-06-2018, 10:08 PM
RE: Question regarding capacitors - by Arran - 03-06-2018, 11:05 PM
RE: Question regarding capacitors - by Arran - 03-07-2018, 07:26 PM
RE: Question regarding capacitors - by Phlogiston - 03-07-2018, 07:45 PM
RE: Question regarding capacitors - by EdHolland - 03-09-2018, 05:32 PM
RE: Question regarding capacitors - by Arran - 03-09-2018, 11:22 PM
RE: Question regarding capacitors - by morzh - 03-10-2018, 09:51 AM
RE: Question regarding capacitors - by Phlogiston - 03-10-2018, 10:22 AM
RE: Question regarding capacitors - by tbone - 03-10-2018, 04:32 PM
RE: Question regarding capacitors - by Phlogiston - 03-10-2018, 09:34 PM
RE: Question regarding capacitors - by morzh - 03-10-2018, 10:15 PM
RE: Question regarding capacitors - by tbone - 03-11-2018, 06:27 AM
RE: Question regarding capacitors - by morzh - 03-11-2018, 07:45 PM
RE: Question regarding capacitors - by Arran - 03-11-2018, 08:08 PM
RE: Question regarding capacitors - by etech - 04-06-2018, 11:43 AM
RE: Question regarding capacitors - by Phlogiston - 04-06-2018, 12:16 PM
RE: Question regarding capacitors - by etech - 04-06-2018, 02:22 PM
RE: Question regarding capacitors - by etech - 04-08-2018, 07:34 AM



Users browsing this thread: 1 Guest(s)