|
Model 90 Cathedral advice
03-30-2018, 04:03 AM
You could also solder in a short terminal strip to the positive terminal under each electrolytic, one with three terminals with the center one being the one with the bracket used to attach the strip to a chassis. But if this model 90 has the original Mershon or Sprague cap cans still in place I would restuff them.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
Model 90 Cathedral advice - by WyTex - 03-27-2018, 09:47 AM
RE: Model 90 Cathedral advice - by morzh - 03-27-2018, 11:15 AM
RE: Model 90 Cathedral advice - by Radioroslyn - 03-27-2018, 11:21 AM
RE: Model 90 Cathedral advice - by Ron Ramirez - 03-27-2018, 04:36 PM
RE: Model 90 Cathedral advice - by WyTex - 03-28-2018, 03:49 AM
RE: Model 90 Cathedral advice - by morzh - 03-28-2018, 07:12 AM
RE: Model 90 Cathedral advice - by Paul Philco322 - 03-28-2018, 08:29 PM
RE: Model 90 Cathedral advice - by Arran - 03-28-2018, 11:23 PM
RE: Model 90 Cathedral advice - by WyTex - 03-29-2018, 11:58 AM
RE: Model 90 Cathedral advice - by morzh - 03-29-2018, 12:30 PM
RE: Model 90 Cathedral advice - by Arran - 03-30-2018, 04:03 AM
RE: Model 90 Cathedral advice - by morzh - 03-30-2018, 07:56 AM
RE: Model 90 Cathedral advice - by Tim Tress - 04-07-2018, 08:03 AM
Users browsing this thread: 3 Guest(s) |
