1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Where to find eyelets and tool(s)?
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#12

04-10-2018, 03:13 PM
(04-09-2018, 12:20 PM)morzh Wrote:  I did the same with my 20 restoration in 2011 - I described it. I used copper rivets, took out the mandrel and used an obtuse-angle cone end tool (in my case - a large screw extracting bit) to flare the rivet.

Can you post a link to the thread you are referring to, please? I searched for it but after looking through two dozen or more results, I gave up.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Where to find eyelets and tool(s)? - by w4rtc - 04-09-2018, 09:49 AM
RE: Where to find eyelets and tool(s)? - by gregb - 04-09-2018, 10:14 AM
RE: Where to find eyelets and tool(s)? - by morzh - 04-09-2018, 12:20 PM
RE: Where to find eyelets and tool(s)? - by Arran - 04-09-2018, 11:11 PM
RE: Where to find eyelets and tool(s)? - by Ron Ramirez - 04-10-2018, 03:13 PM
RE: Where to find eyelets and tool(s)? - by morzh - 04-10-2018, 03:37 PM
RE: Where to find eyelets and tool(s)? - by morzh - 04-12-2018, 07:45 PM



Users browsing this thread: 2 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration