Posts: 496
Threads: 15
Joined: Mar 2013
City: Weymouth Ma
I picked up a 10T last year and due to back issues have done almost nothing with it. Last night I pulled the chassis and it appears to have never been worked on. Tubes had been changed or removed ,stuff like that but no under chassis work was done. The NEARC club meet is in two weeks and I need to make room but after seeing that it may staying for a while. But heavy ,heavy heavy.
Henry
Messages In This Thread
RE: RCA 10T - by radiohenry - 05-22-2018, 11:26 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
RCA WV-98c
|
If this is R22, check the voltage on the wiper (86V).
If this is R33, see if the lower pin indeed connected to GND, the ...morzh — 02:29 PM |
Philco 38-2 Low Volume
|
Both sch, the one you showed in the beginning and the one I see on Nostalgia, show 40K for the 2nd audio plate.morzh — 02:25 PM |
Model 96 cabinet veneer
|
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM |
Philco 38-2 Low Volume
|
I managed to get some more time on this.
Hi Mr. FixIT,
The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM |
Philco 38-2 Low Volume
|
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM |
RCA WV-98c
|
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM |
Philco 38-2 Low Volume
|
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM |
RCA WV-98c
|
Those will probably depend on teh switch combination.
Could you list some that you see, their values and what they sh...morzh — 10:26 AM |
Model 96 cabinet veneer
|
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM |
RCA WV-98c
|
At this point, there is no input, just internal voltages
Which are incorrect and not sure what they should be.daveone23 — 09:15 AM |
Who's Online
|
There are currently 1409 online users. [Complete List] » 3 Member(s) | 1406 Guest(s)
|
|
|
|