|
Help with 48-482
09-04-2018, 11:42 AM
(09-04-2018, 07:46 AM)morzh Wrote: Patrick I took a step back, and used the Philco troubleshooting guide. I have a strong IF signal at the grid of the 1st IF amp. I have only a very weak signal at the plate of the converter. That would indicate a problem at the 1st IF transformer, Z400. So it appears the problem most likely is there, and I was just going off on a tangent somewhere.
« Next Oldest | Next Newest »
Messages In This Thread
Help with 48-482 - by Patrick - 09-03-2018, 09:08 AM
RE: Help with 48-482 - by morzh - 09-03-2018, 04:07 PM
RE: Help with 48-482 - by Patrick - 09-03-2018, 04:18 PM
RE: Help with 48-482 - by morzh - 09-03-2018, 04:23 PM
RE: Help with 48-482 - by Patrick - 09-03-2018, 04:37 PM
RE: Help with 48-482 - by Radioroslyn - 09-03-2018, 07:37 PM
RE: Help with 48-482 - by morzh - 09-03-2018, 07:59 PM
RE: Help with 48-482 - by Patrick - 09-03-2018, 08:23 PM
RE: Help with 48-482 - by Patrick - 09-03-2018, 08:25 PM
RE: Help with 48-482 - by mikethedruid - 09-04-2018, 12:40 AM
RE: Help with 48-482 - by Patrick - 09-04-2018, 04:46 AM
RE: Help with 48-482 - by morzh - 09-04-2018, 07:46 AM
RE: Help with 48-482 - by Patrick - 09-04-2018, 11:42 AM
RE: Help with 48-482 - by Patrick - 09-07-2018, 06:38 AM
Users browsing this thread: 1 Guest(s) |
