Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Radiobar 107 messed up
#4

Yeah,
I'm looking for feedback of what color should go where.  This isn't one I'm keeping, so the plan is to sell.  I'm trying to get top dollar for it, so it needs to look like a million bucks to maximize what I get for it.  I overthought this one and now I'm in pretty deep.  Just wanted to get some feedback of what colors each part should be.  I went with black on the poplar to try to give it strong contrast, but had too much of it and tried for a lighter color that ended up like peanut butter to even it out.  Looking for advice on what colors should go where...

Looking at it this morning again, the grain looks nice, just too much going on with it. Once again I over thought this one.

   


Messages In This Thread
Radiobar 107 messed up - by wardmc1 - 02-27-2019, 08:39 PM
RE: Radiobar 107 messed up - by mikethedruid - 02-27-2019, 08:59 PM
RE: Radiobar 107 messed up - by Arran - 02-28-2019, 04:29 AM
RE: Radiobar 107 messed up - by wardmc1 - 02-28-2019, 07:02 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3905 online users. [Complete List]
» 1 Member(s) | 3904 Guest(s)
Avatar

>