Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dial Calibration Problem on 41-295
#7

Thanks Guys,
I've got some surplus equipment, but nothing has been calibrated in years. I have a Lodestar Signal Generator/Counter, an HP 5315B Universal counter, and a Tektronics 465B Dual Trace scope. All I can say is that the Lodestar and the Hewlett Packard agree within decimals, so I have to assume that the generated frequency is pretty close. With the last re-alignment, I ended up with the lower end of the band indicating "dead on" but the upper end off about 40 Khz. I end up using the pushbuttons, exclusively, so in reality, the whole thing is just an annoyance.

I'm thinking that, at this juncture, with my limited understanding of how the circuits work, and precisely how to affect a solution, I'm probably going to have to live with what I've got.

Henry


Messages In This Thread
Dial Calibration Problem on 41-295 - by hyounce - 12-07-2010, 01:54 PM
Re: Dial Calibration Problem on 41-295 - by hyounce - 12-08-2010, 02:47 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 4024 online users. [Complete List]
» 1 Member(s) | 4023 Guest(s)
Avatar

>