1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Westinghouse H-303P4,
Eric
Senior Member
****
Posts: 450
Threads: 84
Joined: Nov 2011
City: Cumming, GA
#5

07-16-2019, 03:11 PM
Swapped out the 1R5, Put a resistor in parallel and lowered the resistance and increased the filament volts to 1.35V. for some reason I can pick up a tone at 1400 and 2200kc on the signal gen but it will not adjust to the 1615kc with C8.

I re hooked up the DC power supply and I get 1.45V on the filament but reacts the same way. I'm going to pull and recheck the tubes and call it a day this tiny radio is wearing me out!
(This post was last modified: 07-17-2019, 08:34 AM by Eric.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Westinghouse H-303P4, - by Eric - 07-15-2019, 02:31 PM
RE: Westinghouse H-303P4, - by Radioroslyn - 07-15-2019, 03:03 PM
RE: Westinghouse H-303P4, - by Eric - 07-15-2019, 04:34 PM
RE: Westinghouse H-303P4, - by Radioroslyn - 07-15-2019, 04:47 PM
RE: Westinghouse H-303P4, - by Eric - 07-16-2019, 03:11 PM
RE: Westinghouse H-303P4, - by Radioroslyn - 07-17-2019, 06:26 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)