|
Bought X-Tronic 9010 Pro Desoldering station
05-21-2020, 11:58 PM
I have Xytronic 988D. It works OK but the sucked up solder has to go through a tube that is too far from the heater. It plugs up regularly as the solder cools too much before exiting the tube. I have to let the unit heat up for a long time to get the tube hot enough. The unit also lhas a fine tip soldiering iron for fine work on PC boards. I would like to know how you like the unit in the long run.
« Next Oldest | Next Newest »
Messages In This Thread
Bought X-Tronic 9010 Pro Desoldering station - by morzh - 05-21-2020, 10:51 PM
RE: Bought X-Tronic 9010 Pro Desoldering station - by rfeenstra - 05-21-2020, 11:58 PM
RE: Bought X-Tronic 9010 Pro Desoldering station - by Eliot Ness - 05-22-2020, 12:08 AM
RE: Bought X-Tronic 9010 Pro Desoldering station - by morzh - 05-22-2020, 08:55 AM
RE: Bought X-Tronic 9010 Pro Desoldering station - by Eliot Ness - 05-22-2020, 09:32 AM
RE: Bought X-Tronic 9010 Pro Desoldering station - by rfeenstra - 05-22-2020, 10:06 AM
RE: Bought X-Tronic 9010 Pro Desoldering station - by morzh - 05-22-2020, 10:19 AM
Users browsing this thread: 1 Guest(s) |
