|
1935 623F
06-19-2020, 01:36 PM
I have an earth ground hooked up to my chassis .It appears I have .65 amp draw on my 2 volt filament circuit at 1.7 volts but my tubes are not getting warm at all. I have my 3 volt + and -,my 7.5 + and -,my 67.5 is at 64 volt and my 135 volt is at 126.5. I was wondering if those readings are good enough
« Next Oldest | Next Newest »
Messages In This Thread
RE: 1935 623F - by Radioroslyn - 05-18-2020, 12:24 PM
RE: 1935 623F - by RodB - 05-18-2020, 01:00 PM
RE: 1935 623F - by tigercat - 05-18-2020, 04:03 PM
RE: 1935 623F - by Radioroslyn - 05-18-2020, 07:42 PM
RE: 1935 623F - by tigercat - 05-18-2020, 08:06 PM
RE: 1935 623F - by tigercat - 06-19-2020, 01:36 PM
RE: 1935 623F - by Radioroslyn - 06-19-2020, 02:36 PM
RE: 1935 623F - by tigercat - 07-15-2020, 04:08 PM
RE: 1935 623F - by Radioroslyn - 07-16-2020, 05:22 PM
RE: 1935 623F - by tigercat - 07-18-2020, 08:46 AM
RE: 1935 623F - by Radioroslyn - 07-18-2020, 09:04 AM
RE: 1935 623F - by tigercat - 07-18-2020, 11:04 AM
Users browsing this thread: 1 Guest(s) |
