Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

53-956 Philco
#1

Looking for a little help on this radio.  i am somewhat of a beginner on understanding schematics.  For this radio the Base View Part Placement 
diagram shows no connection on 38A & 38B, but the Philco schematic shows different.  The way I see the schematic is:

38A go to Pin 2 of the Output tube
38B go to Pin 1 of the 1st Audio tube
38C go to Pin 7 of the Output tube
38D go to Pin 1 of the Output tube
C26 go to Pin 7 of the Output tube

I got all my info from Nucow Schematics Vol 23, pages 661-666

Any and all help would be much appreciated. 
Once again Thanks,
Rick Clark


Messages In This Thread
53-956 Philco - by Rick Clark - 03-27-2021, 10:31 AM
RE: 53-956 Philco - by David - 03-27-2021, 11:36 AM
RE: 53-956 Philco - by David - 03-27-2021, 11:41 AM
RE: 53-956 Philco - by Radioroslyn - 03-27-2021, 06:08 PM
RE: 53-956 Philco - by Rick Clark - 03-27-2021, 06:29 PM
RE: 53-956 Philco - by David - 03-27-2021, 08:20 PM
RE: 53-956 Philco - by mikethedruid - 03-27-2021, 09:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 4481 online users. [Complete List]
» 2 Member(s) | 4479 Guest(s)
AvatarAvatar

>