Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA R-32 Speaker
#3

Hey Terry
I have never come across a FC with such a high resistance before (not that I'm that experienced). Usually they seem to fall in the range of 650-2000 ohms but this is such an early set for me.


Input is 110vac resistance across FC is 7K Ohms
So I checked the voltage drop across the FC and I get 222vdc
The individual FC leads are
 302v
 -81v
  221v

the plate voltage from #1 45 is 290vdc
         "         "        "   #2 45 is 302vdc 

so E/R, 222v/7000r=.03a
E/R, 222/.03a=7400 ohms
So it looks like @ 7K the field looks good? Or the bigger question is my math correct!

Thanks
Eric


Messages In This Thread
RCA R-32 Speaker - by Eric - 04-07-2021, 04:34 PM
RE: RCA R-32 Speaker - by Radioroslyn - 04-07-2021, 04:55 PM
RE: RCA R-32 Speaker - by Eric - 04-08-2021, 09:43 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 10:55 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:11 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:20 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:50 AM
RE: RCA R-32 Speaker - by Eric - 04-08-2021, 04:42 PM
RE: RCA R-32 Speaker - by Eric - 04-09-2021, 08:39 AM
RE: RCA R-32 Speaker - by rghines1 - 04-09-2021, 04:07 PM
RE: RCA R-32 Speaker - by OZ4 - 04-10-2021, 09:17 AM
RE: RCA R-32 Speaker - by Eric - 04-10-2021, 10:48 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3861 online users. [Complete List]
» 1 Member(s) | 3860 Guest(s)
Avatar

>