Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA R-32 Speaker
#5

The highest voltage on the chart I see is 260 volts so the power supply is likely to be some 300 to 350 volts. 

That would mean the choke voltage should be on the lower end. 

!!!!!!!!!!!!!!!!!!!RESISTANCE IS FUTILE!!!!!!!!!!!!!!!!!!!!!!  
                           /\/\/\/\/\/\/\/\/\
                                                     
                                 [Image: http://philcoradio.com/phorum/images/smi...on_eek.gif]  Chris


Messages In This Thread
RCA R-32 Speaker - by Eric - 04-07-2021, 04:34 PM
RE: RCA R-32 Speaker - by Radioroslyn - 04-07-2021, 04:55 PM
RE: RCA R-32 Speaker - by Eric - 04-08-2021, 09:43 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 10:55 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:11 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:20 AM
RE: RCA R-32 Speaker - by OZ4 - 04-08-2021, 11:50 AM
RE: RCA R-32 Speaker - by Eric - 04-08-2021, 04:42 PM
RE: RCA R-32 Speaker - by Eric - 04-09-2021, 08:39 AM
RE: RCA R-32 Speaker - by rghines1 - 04-09-2021, 04:07 PM
RE: RCA R-32 Speaker - by OZ4 - 04-10-2021, 09:17 AM
RE: RCA R-32 Speaker - by Eric - 04-10-2021, 10:48 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM
Philco 91 Speaker Replacement
I was wondering if I could use a more common Philco speaker and just add the resistance I need for the coil and get a ne...dconant — 07:45 AM

[-]
Who's Online
There are currently 2357 online users. [Complete List]
» 2 Member(s) | 2355 Guest(s)
AvatarAvatar

>