1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
An Introduction and a Philco 90 issue.
cknob
Member
***
Posts: 51
Threads: 3
Joined: Nov 2021
City: Drexel Hill State, Province, Country: PA
#38

11-26-2021, 11:55 PM
Chassis ground on the meter and test lead to wire that was connected to terminal 3 shows 0 ohms. I then connected the test lead to the line that was attached to terminal 4 and got 3200 ohms. That wire from terminal 4 terminates and is soldered to one of the external speaker sockets.
Find
« Next Oldest | Next Newest »


Messages In This Thread
An Introduction and a Philco 90 issue. - by cknob - 11-23-2021, 08:20 PM
RE: An Introduction and a Philco 90 issue. - by cknob - 11-26-2021, 11:55 PM



Users browsing this thread: 2 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration