01-27-2022, 10:01 AM
I just purchased this Philco but I’m confused as to what schematic is required. There is a label inside the cabinet that reads Model 89 Series 19 and that is also marked by someone on the chassis as well. The issue is the schematic I downloaded doesn’t fit to what I’m looking at with my radio.
http://www.nostalgiaair.org/pagesbymodel...013877.pdf
The tubes in this radio are 2-39/44, 80, 42, 75 and a 36
I’m including photos of the cabinet and chassis. This radio has had work done previously and only has three bakelite blocks in it as opposed to what the schematic from Nostagiaair shows. I would also like to know about the two blue circled capacitors. I’m unfamiliar with them and assume they should be replaced?
I’m very new to this hobby so any assistance or advice would be greatly appreciated.
http://www.nostalgiaair.org/pagesbymodel...013877.pdf
The tubes in this radio are 2-39/44, 80, 42, 75 and a 36
I’m including photos of the cabinet and chassis. This radio has had work done previously and only has three bakelite blocks in it as opposed to what the schematic from Nostagiaair shows. I would also like to know about the two blue circled capacitors. I’m unfamiliar with them and assume they should be replaced?
I’m very new to this hobby so any assistance or advice would be greatly appreciated.
