07-28-2022, 12:09 PM
If you have voltage on the plate of 6K7 (RF) and the plate of 6K7 (IF) then something must be wired incorrectly. Check both sides of the IF (#10) for voltage. Then check at R23 and then the junction of R8 & R7. If you have voltage at the resistors but none on either side of the IF (#10) then it isn't connected to where it should be.
In-other-words, if you have voltage at point A and B but not C, then there must be a disconnect between point C and D.
In-other-words, if you have voltage at point A and B but not C, then there must be a disconnect between point C and D.
John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
