Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1st IF can cover removal Philco 118 Help
#7

>Caps and resistors seemed ok.
If you haven't replaced the caps in all of the bakelike blocks and the four in #46. On #46 you can use 2.2mfd@450dc or 4.7mfd in a pinch for all.

Without replacing these these caps your asking for squeals, odd oscillation, and just general bad intermittent bad behavior.

I doubt that the IFt is the issue but is a red herring.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread



Users browsing this thread: 1 Guest(s)