11-02-2022, 05:31 PM
Welcome to the Phorum!
So and original 630X would look like this: https://philcoradio.com/gallery2/1936a/#Model_630X
Two ways to get a new front panel would be to
1) make one yourself with new veneer and inlay. If you do that then you can cut the openings in the panel to fit whatever chassis you are going to put into it or..
2) get a panel from a donor set which will have the knob holes and escutcheon opening that fit the 630x chassis.
You can put a Wanted Ad in our Wanted Ad section, keep an eye on ebay and Craigs List and check out any vintage radio swap meets that might be in your area. I also moved this thread into the Cabinet Restoration section.
So and original 630X would look like this: https://philcoradio.com/gallery2/1936a/#Model_630X
Two ways to get a new front panel would be to
1) make one yourself with new veneer and inlay. If you do that then you can cut the openings in the panel to fit whatever chassis you are going to put into it or..
2) get a panel from a donor set which will have the knob holes and escutcheon opening that fit the 630x chassis.
You can put a Wanted Ad in our Wanted Ad section, keep an eye on ebay and Craigs List and check out any vintage radio swap meets that might be in your area. I also moved this thread into the Cabinet Restoration section.
