05-21-2023, 05:44 PM
"Zemmie", hope you get it figured out, or as one guy said a short break may help when you come back to it.
I was searching for any other info on the control and ran across your post here.
On the FB thread I asked if you have checked the coils for continuity. I also mentioned that on some low voltage , low current tubes, the filament may not easily be seen unless the room is really dark.
I know you will figure it out, it's these kind of issues that gove is fits sometimes.
Take care. Gary Maker (Rabbitt).
I was searching for any other info on the control and ran across your post here.
On the FB thread I asked if you have checked the coils for continuity. I also mentioned that on some low voltage , low current tubes, the filament may not easily be seen unless the room is really dark.
I know you will figure it out, it's these kind of issues that gove is fits sometimes.
Take care. Gary Maker (Rabbitt).
