Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 87
#12

I found that I also had an open primary winding on the antenna transformer. I rewound that coil with 24 turns of #31 wire and
also rewound the 2nd RF coil primary with 14 turns of the same gauge wire. Surprisingly, the receiver works really good.
I tried to do the neutralizing alignment using a dummy tube but the audio level of the 700 khz signal I generate with 400 hz modulation
drops so much that my AC Simpson AC volt meter across the voice coil doesn't read it, So I think I will not mess with it.
Fred


Messages In This Thread
Philco Model 87 - by fwmartin2000 - 08-29-2023, 07:28 PM
RE: Philco Model 87 - by MrFixr55 - 08-29-2023, 08:07 PM
RE: Philco Model 87 - by Radioroslyn - 08-29-2023, 08:17 PM
RE: Philco Model 87 - by morzh - 08-29-2023, 09:35 PM
RE: Philco Model 87 - by radiorich - 08-29-2023, 11:15 PM
RE: Philco Model 87 - by fwmartin2000 - 08-30-2023, 10:53 AM
RE: Philco Model 87 - by Radioroslyn - 08-30-2023, 11:19 AM
RE: Philco Model 87 - by morzh - 08-30-2023, 06:16 PM
RE: Philco Model 87 - by fwmartin2000 - 08-30-2023, 08:22 PM
RE: Philco Model 87 - by Chas - 08-30-2023, 10:43 PM
RE: Philco Model 87 - by morzh - 08-31-2023, 09:08 AM
RE: Philco Model 87 - by fwmartin2000 - 09-06-2023, 02:16 PM
RE: Philco Model 87 - by Chas - 09-06-2023, 04:17 PM
RE: Philco Model 87 - by fwmartin2000 - 09-07-2023, 07:51 PM



Users browsing this thread: 1 Guest(s)