|
Tube Testing - 46-200
08-20-2012, 12:53 PM
Don't think it's that critical, but I'd be inclined to use up some enameled 22 guage from a trashed transformer secondary that is not burned up, or simple insulated hookup wire. If you follow the pattern and get everything hooked up OK, you should be good. Might need a touch up on alignment though.
« Next Oldest | Next Newest »
Messages In This Thread
Tube Testing - 46-200 - by winkydink - 08-19-2012, 08:45 AM
RE: Tube Testing - 46-200 - by Ron Ramirez - 08-19-2012, 09:27 AM
RE: Tube Testing - 46-200 - by winkydink - 08-19-2012, 10:29 AM
RE: Tube Testing - 46-200 - by codefox1 - 08-19-2012, 12:01 PM
RE: Tube Testing - 46-200 - by Paul Philco322 - 08-19-2012, 07:17 PM
RE: Tube Testing - 46-200 - by winkydink - 08-20-2012, 07:37 AM
RE: Tube Testing - 46-200 - by Ron Ramirez - 08-20-2012, 07:45 AM
RE: Tube Testing - 46-200 - by codefox1 - 08-20-2012, 12:17 PM
RE: Tube Testing - 46-200 - by winkydink - 08-20-2012, 12:26 PM
RE: Tube Testing - 46-200 - by codefox1 - 08-20-2012, 12:53 PM
RE: Tube Testing - 46-200 - by Ron Ramirez - 08-20-2012, 03:29 PM
RE: Tube Testing - 46-200 - by winkydink - 08-20-2012, 08:47 PM
RE: Tube Testing - 46-200 - by winkydink - 09-04-2012, 07:29 AM
RE: Tube Testing - 46-200 - by Ron Ramirez - 09-04-2012, 07:44 AM
RE: Tube Testing - 46-200 - by winkydink - 09-04-2012, 07:58 AM
RE: Tube Testing - 46-200 - by Ron Ramirez - 09-04-2012, 08:22 AM
RE: Tube Testing - 46-200 - by TimC - 09-07-2012, 09:26 PM
Users browsing this thread: 2 Guest(s) |
