09-04-2007, 10:07 PM
Hello everyone,
I have some questions about the recapping i am doing on the 46-1201 code 121.
1. Can a 503k replace a .04 mfd cap?
2. Is the C 15 (Rider's) where the 0.25, 275 V safety cap goes--i want to make absolutely sure before i solder it.
3. I soldered the 0.05 safety cap in the C 12 .05 mfd--was this right?
4. On the bottom, left side of the chassis, there was what i believe to be a electrolytic--on this cap it has--code red, 15 mfd, 150 V, Black is Negative, which i replaced with a 15 uf, 160 V electrolytic.
Rider's says it is a R 7--does R stand for resistor?
I replaced 3 electrolytic caps--i am hoping this radio only takes 3, & that i soldered them in the right places.
Can anyone help me on these 4 questions ?
diyahnih
I have some questions about the recapping i am doing on the 46-1201 code 121.
1. Can a 503k replace a .04 mfd cap?
2. Is the C 15 (Rider's) where the 0.25, 275 V safety cap goes--i want to make absolutely sure before i solder it.
3. I soldered the 0.05 safety cap in the C 12 .05 mfd--was this right?
4. On the bottom, left side of the chassis, there was what i believe to be a electrolytic--on this cap it has--code red, 15 mfd, 150 V, Black is Negative, which i replaced with a 15 uf, 160 V electrolytic.
Rider's says it is a R 7--does R stand for resistor?
I replaced 3 electrolytic caps--i am hoping this radio only takes 3, & that i soldered them in the right places.
Can anyone help me on these 4 questions ?
diyahnih
