|
My next project, dad's Philco 40-81
01-21-2013, 10:19 PM
I looked up the schematic again after this and it seems to note B+ readings of 69 volts so the special battery pack may have been in the 70 volt range rather then 67-1/2. I'm sure you could connect 72 volts to it without cooking anything, but if you are worried about it you could connect a few silicon diodes in series with the + side, or between B+ and B- to cut it down.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
My next project, dad's Philco 40-81 - by 37silverstreak - 01-17-2013, 09:20 PM
RE: My next project, dad's Philco 40-81 - by TA Forbes - 01-18-2013, 12:31 AM
RE: My next project, dad's Philco 40-81 - by Arran - 01-18-2013, 02:42 AM
RE: My next project, dad's Philco 40-81 - by TA Forbes - 01-18-2013, 11:06 AM
RE: My next project, dad's Philco 40-81 - by Ron Ramirez - 01-20-2013, 08:39 AM
RE: My next project, dad's Philco 40-81 - by 37silverstreak - 01-20-2013, 02:51 PM
RE: My next project, dad's Philco 40-81 - by Chris Cusick - 01-20-2013, 04:28 PM
RE: My next project, dad's Philco 40-81 - by Arran - 01-21-2013, 10:19 PM
RE: My next project, dad's Philco 40-81 - by codefox1 - 01-22-2013, 02:51 PM
Users browsing this thread: 3 Guest(s) |
