|
Help Philco 42-327
02-08-2013, 01:17 AM
It is entirely possible that the oscillator for the broadcast band isn't functioning for some reason, a bad resistor, a bad mica cap, or even an open oscillator coil could cause this. I would start checking voltages on the XXD tube, particularly the oscillator section.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
Help Philco 42-327 - by Eric - 02-07-2013, 03:29 PM
RE: Help Philco 42-327 - by 7estatdef - 02-07-2013, 05:07 PM
RE: Help Philco 42-327 - by Eric - 02-07-2013, 08:04 PM
RE: Help Philco 42-327 - by 7estatdef - 02-07-2013, 10:08 PM
RE: Help Philco 42-327 - by Arran - 02-07-2013, 10:52 PM
RE: Help Philco 42-327 - by Arran - 02-08-2013, 01:17 AM
RE: Help Philco 42-327 - by gary rabbitt - 02-08-2013, 01:47 AM
RE: Help Philco 42-327 - by exray - 02-08-2013, 07:20 AM
RE: Help Philco 42-327 - by Eric - 02-08-2013, 12:08 PM
RE: Help Philco 42-327 - by Eric - 02-08-2013, 05:12 PM
RE: Help Philco 42-327 - by Eric - 02-09-2013, 12:09 PM
RE: Help Philco 42-327 - by codefox1 - 02-09-2013, 12:17 PM
RE: Help Philco 42-327 - by exray - 02-10-2013, 05:36 AM
Users browsing this thread: 1 Guest(s) |
