Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-38T - different than schematics
#1

Hi, been lurking for awhile as I have a couple of radios that I have told myself I will repair before the end of days. One set in particular is a 38-38T

The 38-38T has a label that states it Series 121 but only has 5 Tubes, 1C7G 1D5GT 1H4G 1J6G 1F7G which matches the tube location label.

Riders schematic for the 38-38T shows “series 121” but shows 6 tubes – Beitman schematic also shows 6 tubes don’t recall if it shows code,

Logic says the 1F7G (Double Diode - Pentode) is utilizing 1-Diode as 2nd Detector Stage, 1-Diode for AVC and the Pentode as 1st Audio Stage since these are the functions of the two replaced tubes but I have not yet traced the wiring.

I can most likely alter the 6-Tube schematic by tracking the wiring but would kinda like a schematic to verify voltage and component value.

Any ideas on where I might locate a schematic/service info for this "unique" set?

Thanks,
Blake


Attached Files Image(s)
                   


Messages In This Thread
Philco 38-38T - different than schematics - by Unekidden - 06-12-2013, 12:35 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 4685 online users. [Complete List]
» 1 Member(s) | 4684 Guest(s)
Avatar

>