02-28-2008, 02:05 PM
i just looked at the schematic again,i only see one resistor to ground and the filter block,part #45 at 10k. i didn't think wire wounds were usually this high in value,do you see any other posibilities?
philco 296 cap i.d.
« Next Oldest | Next Newest »
Messages In This Thread
philco 296 cap i.d. - by philco phan - 02-28-2008, 01:16 PM
[No subject] - by Chuck Schwark - 02-28-2008, 01:26 PM
[No subject] - by philco phan - 02-28-2008, 01:58 PM
[No subject] - by philco phan - 02-28-2008, 02:05 PM
[No subject] - by Chuck Schwark - 02-28-2008, 06:08 PM
Users browsing this thread: 1 Guest(s) |