Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 645 Hum-m-m-m
#37

Well, it can be a volt or two WITH the load (rect neg is connected to the GND via small resistor) but for practical purposes it is zero.


Messages In This Thread
Philco 645 Hum-m-m-m - by Winky Dink - 04-07-2014, 07:21 PM
RE: Philco 645 Hum-m-m-m - by gregb - 04-07-2014, 07:24 PM
RE: Philco 645 Hum-m-m-m - by Warren - 04-07-2014, 08:05 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-07-2014, 08:23 PM
RE: Philco 645 Hum-m-m-m - by Ron Ramirez - 04-08-2014, 04:31 AM
RE: Philco 645 Hum-m-m-m - by morzh - 04-08-2014, 09:10 AM
RE: Philco 645 Hum-m-m-m - by PAradiogeek - 04-08-2014, 10:16 AM
RE: Philco 645 Hum-m-m-m - by TA Forbes - 04-08-2014, 12:26 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-08-2014, 11:54 PM
RE: Philco 645 Hum-m-m-m - by TA Forbes - 04-09-2014, 09:58 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-09-2014, 12:45 PM
RE: Philco 645 Hum-m-m Fixed? - by Winky Dink - 04-12-2014, 09:43 AM
RE: Philco 645 Hum-m-m-m - by Steve Davis - 04-12-2014, 10:36 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-12-2014, 10:57 AM
RE: Philco 645 Hum-m-m-m - by TA Forbes - 04-12-2014, 11:04 AM
RE: Philco 645 Hum-m-m-m - by BrendaAnnD - 04-12-2014, 03:18 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-13-2014, 04:14 AM
RE: Philco 645 Hum-m-m-m - by morzh - 04-13-2014, 08:28 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-14-2014, 12:29 AM
RE: Philco 645 Hum-m-m-m - by morzh - 04-14-2014, 07:23 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-16-2014, 03:28 AM
RE: Philco 645 Hum-m-m-m - by morzh - 04-16-2014, 09:30 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-16-2014, 03:24 PM
RE: Philco 645 Hum-m-m-m - by TA Forbes - 04-16-2014, 03:43 PM
RE: Philco 645 Hum-m-m-m - by morzh - 04-16-2014, 04:05 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-17-2014, 03:54 AM
RE: Philco 645 Hum-m-m-m - by morzh - 04-17-2014, 07:54 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 04-18-2014, 12:08 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-02-2014, 10:20 PM
RE: Philco 645 Hum-m-m-m - by Arran - 07-02-2014, 11:21 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-03-2014, 12:53 AM
RE: Philco 645 Hum-m-m-m - by morzh - 07-03-2014, 08:45 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-03-2014, 11:37 PM
RE: Philco 645 Hum-m-m-m - by morzh - 07-05-2014, 10:09 PM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-06-2014, 12:57 AM
RE: Philco 645 Hum-m-m-m - by morzh - 07-06-2014, 07:58 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-06-2014, 08:30 AM
RE: Philco 645 Hum-m-m-m - by morzh - 07-06-2014, 09:16 AM
RE: Philco 645 Hum-m-m-m - by Winky Dink - 07-07-2014, 07:04 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5378 online users. [Complete List]
» 1 Member(s) | 5377 Guest(s)
Avatar

>