Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Is it worth rebuilding?
#4

If you have time, I'd give it a try. At least you wouldn't have to interpolate when using said instrument on period specimens. It's worth it to you.


Messages In This Thread
Is it worth rebuilding? - by GarySP - 07-08-2014, 09:28 AM
RE: Is it worth rebuilding? - by klondike98 - 07-08-2014, 09:37 AM
RE: Is it worth rebuilding? - by morzh - 07-08-2014, 09:43 AM
RE: Is it worth rebuilding? - by codefox1 - 07-09-2014, 09:44 PM
RE: Is it worth rebuilding? - by TA Forbes - 07-10-2014, 06:17 PM
RE: Is it worth rebuilding? - by codefox1 - 07-11-2014, 09:30 AM
RE: Is it worth rebuilding? - by brownie45 - 07-13-2014, 09:14 PM
RE: Is it worth rebuilding? - by tom.seeger - 07-13-2014, 09:34 PM
RE: Is it worth rebuilding? - by Arran - 07-14-2014, 07:28 AM
RE: Is it worth rebuilding? - by GarySP - 07-14-2014, 11:02 AM
RE: Is it worth rebuilding? - by Paul Philco322 - 07-15-2014, 09:00 PM
RE: Is it worth rebuilding? - by GarySP - 07-26-2014, 10:55 AM
RE: Is it worth rebuilding? - by GarySP - 07-26-2014, 11:03 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3882 online users. [Complete List]
» 1 Member(s) | 3881 Guest(s)
Avatar

>