Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Craigslist GE E-81
#7

In Canada the RCA-Victor Company of Montreal, and the Canadian General Electric Company of Toronto shared chassis with one another. It was not quite like in the U.S where RCA made chassis for G.E and Westinghouse from 1930-34 though, they were actually made in two separate factories, and they used entirely different cabinets. In the U.S that was the result of an anti trust judgement against RCA's patent pool in 1930, it did not apply to Canada. Many Canadian RCA and G.E sets shared chassis, right up into the late 1940s, but the ones from 1939 onward were often uniquely Canadian designed like the JK-70 or A-23 for examples.
The RCA version of this set was an 8T in the U.S, or an 8T1 in Canada, I picked up a chassis from a U.S RCA 7K for replacing my badly rusted chassis in my CGE E-81 about a year ago. The E-81 on Radio Attic is entirely original cabinet wise, note that the strip of veneer bellow the knobs was shaded like the rest of the bottom 3'' of the cabinet. It would be interesting to have an example of each set to compare, although I think that the U.S E-81 would likely win given the tuned R.F amplifier stage, the Canadian E-81 has separate mixer and oscillator tubes which may help on shortwave, both wasted a socket on that useless 6H6 tube.
Regards
Arran


Messages In This Thread
Craigslist GE E-81 - by Groundhog74 - 08-27-2014, 05:26 PM
RE: Craigslist GE E-81 - by OldRestorer - 08-27-2014, 05:56 PM
RE: Craigslist GE E-81 - by Groundhog74 - 08-27-2014, 07:33 PM
RE: Craigslist GE E-81 - by Arran - 08-27-2014, 10:47 PM
RE: Craigslist GE E-81 - by morzh - 08-28-2014, 09:05 AM
RE: Craigslist GE E-81 - by Dan Walker - 08-28-2014, 06:15 PM
RE: Craigslist GE E-81 - by Arran - 08-28-2014, 10:40 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5354 online users. [Complete List]
» 1 Member(s) | 5353 Guest(s)
Avatar

>