|
Philco 42-395
12-30-2008, 12:20 PM
On the 10 button plate no one makes a reproduction, I am one who is somewhat lucky that my 42-1011 has a decent 10 button plate. I did inquire about a new one from Larry but he said the demand was low and the cost high for set up molds so that making reproductions was out of the question at this time.
« Next Oldest | Next Newest »
Messages In This Thread
Philco 42-395 - by Guest - 10-12-2008, 06:36 AM
RE: Philco 42-395 - by lasttoknow - 05-25-2012, 11:23 AM
Re: Philco 42-395 - by Ron Ramirez - 10-12-2008, 10:14 AM
Re: Philco 42-395 - by Guest - 10-12-2008, 11:40 AM
Re: Philco 42-395 - by Ron Ramirez - 10-13-2008, 06:09 PM
Re: Philco 42-395 - by Guest - 11-15-2008, 09:38 AM
Re: Philco 42-395 - by Ron Ramirez - 11-15-2008, 01:49 PM
Re: Philco 42-395 - by Guest - 11-15-2008, 02:32 PM
Re: Philco 42-395 - by Guest - 12-28-2008, 03:50 PM
Re: Philco 42-395 - by Doug Houston - 12-28-2008, 04:14 PM
Re: Philco 42-395 - by Guest - 12-28-2008, 05:16 PM
Re: Philco 42-395 - by 49Stude63 - 12-30-2008, 12:20 PM
Re: Philco 42-395 - by Guest - 12-30-2008, 01:06 PM
Re: Philco 42-395 - by 49Stude63 - 12-30-2008, 01:10 PM
Re: Philco 42-395 - by Guest - 12-30-2008, 01:25 PM
Users browsing this thread: 1 Guest(s) |
