Posts: 15,691
Threads: 551
Joined: Oct 2011
City: Jackson, NJ
No, no mold.
The guy who sold it to me (in Kutztown) held it sitting on the wet grass...the plywood at the bottom was cracking. Dry rot pretty much.
The rest was OK. One wall was buckling a bit, but I am not sure that had to do with moisture at all.
And then, mold is good for you.
These are done with mold.
1. Soft ripened and blue cheeses.
2. Penicillin.
I personally cannot live without blue cheese. The rest of humanity cannot live without penicillin.
So, talk about doing a guy a favour and then getting scorned for it!!!!
Messages In This Thread
RE: Kirk's Jackson Bell 62 - by morzh - 02-11-2015, 09:14 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Delco car radio Peko vibrator converstion issues
|
Rich,
There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM |
Jackson 715 not working
|
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM |
Jackson 715 not working
|
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM |
HiFi (Chifi) tube amp build - but my own design.
|
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM |
Jackson 715 not working
|
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM |
Restoring Philco 37-604C
|
Yep. F5 is green, D5 is Red.
Red is Bad.
Green is Clean.morzh — 01:30 PM |
Jackson 715 not working
|
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM |
Restoring Philco 37-604C
|
(Insert Homer Simpson "DOPF" Here.)
When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM |
Philco 91 Speaker Replacement
|
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil.
It wo...morzh — 08:44 AM |
Philco 91 Speaker Replacement
|
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM |
Who's Online
|
There are currently 2965 online users. [Complete List] » 2 Member(s) | 2963 Guest(s)
|
|
|
|