Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

You guys did this to me!
#12

Here are the schematics.

Modernization was done at the factory.

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan


Messages In This Thread
You guys did this to me! - by GarySP - 01-17-2015, 11:35 AM
RE: You guys did this to me! - by codefox1 - 01-17-2015, 03:40 PM
RE: You guys did this to me! - by GarySP - 01-23-2015, 11:50 AM
RE: You guys did this to me! - by Eliot Ness - 01-23-2015, 01:25 PM
RE: You guys did this to me! - by GarySP - 01-24-2015, 10:57 AM
RE: You guys did this to me! - by Eliot Ness - 01-26-2015, 03:42 PM
RE: You guys did this to me! - by Chuck Schwark - 01-26-2015, 03:47 PM
RE: You guys did this to me! - by GarySP - 02-27-2015, 08:25 AM
RE: You guys did this to me! - by Radioroslyn - 03-10-2015, 08:48 PM
RE: You guys did this to me! - by GarySP - 03-15-2015, 12:36 PM
RE: You guys did this to me! - by Mondial - 03-15-2015, 05:15 PM
RE: You guys did this to me! - by GarySP - 03-15-2015, 09:21 PM
RE: You guys did this to me! - by GarySP - 03-15-2015, 09:22 PM
RE: You guys did this to me! - by GarySP - 03-15-2015, 09:25 PM
RE: You guys did this to me! - by Mondial - 03-16-2015, 07:24 PM
RE: You guys did this to me! - by GarySP - 03-17-2015, 09:58 AM
RE: You guys did this to me! - by emcgill - 10-16-2019, 09:06 PM
RE: You guys did this to me! - by emcgill - 10-26-2019, 06:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM
Philco 91 Speaker Replacement
I was wondering if I could use a more common Philco speaker and just add the resistance I need for the coil and get a ne...dconant — 07:45 AM

[-]
Who's Online
There are currently 2124 online users. [Complete List]
» 3 Member(s) | 2121 Guest(s)
AvatarAvatarAvatar

>