Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phonograph motor fried??
#2

It is usually ac going to the motor,if you are using your meter on ac volts and not getting any power then it sounds like for some reason your not getting power to the motor. Also, if someone wired it directly to ac then it kind of tells you they had the problem too. I would find out why your not getting ac to the motor... check the schematics and find out where your losing power.


Messages In This Thread
Phonograph motor fried?? - by ODPILOT - 05-28-2015, 01:02 PM
RE: Phonograph motor fried?? - by Warren - 05-28-2015, 02:13 PM
RE: Phonograph motor fried?? - by ODPILOT - 05-30-2015, 08:10 AM
RE: Phonograph motor fried?? - by jerryhawthorne - 05-30-2015, 01:37 PM
RE: Phonograph motor fried?? - by ODPILOT - 06-01-2015, 10:49 AM
RE: Phonograph motor fried?? - by morzh - 06-01-2015, 10:58 AM
RE: Phonograph motor fried?? - by sam - 06-02-2015, 03:14 AM
RE: Phonograph motor fried?? - by ODPILOT - 06-02-2015, 11:19 AM
RE: Phonograph motor fried?? - by morzh - 06-02-2015, 12:13 PM
RE: Phonograph motor fried?? - by sam - 06-02-2015, 07:01 PM
RE: Phonograph motor fried?? - by morzh - 06-02-2015, 08:31 PM
RE: Phonograph motor fried?? - by sam - 06-03-2015, 03:35 AM
RE: Phonograph motor fried?? - by morzh - 06-03-2015, 08:20 AM
RE: Phonograph motor fried?? - by sam - 06-03-2015, 11:26 AM
RE: Phonograph motor fried?? - by morzh - 06-03-2015, 02:12 PM
RE: Phonograph motor fried?? - by jerryhawthorne - 06-03-2015, 02:45 PM
RE: Phonograph motor fried?? - by morzh - 06-03-2015, 02:58 PM
RE: Phonograph motor fried?? - by jerryhawthorne - 06-03-2015, 03:36 PM
RE: Phonograph motor fried?? - by sam - 06-03-2015, 06:17 PM
RE: Phonograph motor fried?? - by ODPILOT - 06-03-2015, 08:06 PM
RE: Phonograph motor fried?? - by sam - 06-04-2015, 02:46 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM

[-]
Who's Online
There are currently 3051 online users. [Complete List]
» 2 Member(s) | 3049 Guest(s)
AvatarAvatar

>