Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Screws for Grille Cloth Plate on Cathedrals
#2

(06-01-2015, 12:38 PM)markmokris Wrote:  Does anyone know if there is a source for the decorative screws that hold the grille cloth plate in place on the 1930s Philco Cathedrals (Model 19, Model 89, Model 80, etc).  They all use these same screws.  The head is sort of dark brown, and looks a bit like a rosette.  

I am referring to the screws that are exposed to the outside front of the radio.

Thanks,

Mark

EDIT: Aw!  I think I put the in the wrong forum.  Sorry!

I just talked to Mark Oppat, and he says that he has the screws.

Mark


Messages In This Thread
RE: Philco Screws for Grille Cloth Plate on Cathedrals - by markmokris - 06-01-2015, 02:53 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 4026 online users. [Complete List]
» 1 Member(s) | 4025 Guest(s)
Avatar

>