Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

half the tubes check bad
#6

(07-13-2015, 12:04 PM)Nick3092 Wrote:  Bad or weak tubes on a tester don't always translate into non functioning tubes. I would start by doing voltage checks (assuming you have a DMM) on the tube pins to make sure they are within reason of what is provided on the schematic. What other testing tools (sig gen, tracer, etc...) so you have, if any?

I have a multimeter and an old heathkit signal generator.


Messages In This Thread
half the tubes check bad - by doc612 - 07-13-2015, 11:01 AM
RE: half the tubes check bad - by Nick3092 - 07-13-2015, 12:04 PM
RE: half the tubes check bad - by doc612 - 07-13-2015, 03:21 PM
RE: half the tubes check bad - by morzh - 07-13-2015, 12:14 PM
RE: half the tubes check bad - by doc612 - 07-13-2015, 03:22 PM
RE: half the tubes check bad - by TA Forbes - 07-13-2015, 12:40 PM
RE: half the tubes check bad - by TA Forbes - 07-13-2015, 12:41 PM
RE: half the tubes check bad - by doc612 - 07-13-2015, 03:25 PM
RE: half the tubes check bad - by TA Forbes - 07-13-2015, 07:36 PM
RE: half the tubes check bad - by doc612 - 09-09-2015, 10:19 PM
RE: half the tubes check bad - by klondike98 - 09-09-2015, 10:37 PM
RE: half the tubes check bad - by tom.seeger - 09-12-2015, 09:03 AM



Users browsing this thread: 1 Guest(s)