Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1950 Philco 50T-1477
#3

(10-23-2015, 12:22 AM)Bob Andersen Wrote:  It's an uncommon model, but looks pretty rough.  There's  phonograph in the top and I wonder what condition it's in.  Even if it's not rusty, that cabinet will need a lot of work.  Also needs new grille cloth and the safety glass looks like it is starting to separate at the top.  

Personally, I might go $100 because I like this model, like a challenge and have spare parts.

Thanks Bob for the quick reply.

Crist


Messages In This Thread
1950 Philco 50T-1477 - by Crist Rigotti - 10-22-2015, 10:22 PM
RE: 1950 Philco 50T-1477 - by Bob Andersen - 10-23-2015, 12:22 AM
RE: 1950 Philco 50T-1477 - by Crist Rigotti - 10-23-2015, 12:32 AM
RE: 1950 Philco 50T-1477 - by Arran - 11-03-2015, 10:38 PM
RE: 1950 Philco 50T-1477 - by Crist Rigotti - 11-04-2015, 12:30 AM
RE: 1950 Philco 50T-1477 - by codefox1 - 12-02-2015, 05:32 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3952 online users. [Complete List]
» 1 Member(s) | 3951 Guest(s)
Avatar

>