07-14-2015, 11:15 AM
Where can I find a tool for adjusting the trimmers (compensating condensers) in the Philco Cathedrals (Model 60, 89, etc)? It looks like I need a small socket wrench-type tool (pencil size) that will fit the little hole and the little nut. It should be non-metallic of course.
It has to be somewhat "hollow", since there is usually the end of a threaded post sticking out through the adjusting nut.
You guys know what I mean.
I try to adjust them from the side with a pair of needle noose pliers. To say this doesn't work very well is an understatement.
Thanks,
Mark K8KZ
It has to be somewhat "hollow", since there is usually the end of a threaded post sticking out through the adjusting nut.
You guys know what I mean.
I try to adjust them from the side with a pair of needle noose pliers. To say this doesn't work very well is an understatement.
Thanks,
Mark K8KZ
