Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another RCA done
#6

   I checked all the tubes and ,they are all very good.
 as far as the cabinet is concerned , I had to strip it , and that was not too hard  because there was not much on a finish put on by whoever did it. Once it was stripped I gave it a coat of dark walnut stain. [I use that a lot]
next I used a sealer of one part shellac and 5 parts methyl hydrate.  I masked it off and used Mohawk, Vandyke brown for the trim,  and Extra dark walnut for the bottom.
Then I used a clear lacquer satin. I put three coats of that on. between each coat I used 4000 grit[if you can call that a GRIT] between coats.. Just enough to take away any small bumps. and for the final coats I used high gloss.
  The reason I used high gloss is that the radio has been bought by some friends of mine that are going to raffle
it off at their car show.. Most of the public seems to like that shiny look.
  I had to reverse the grill cloth ;it is backwards but it looks better that way
   That wood on the sides is all original with matched wood on both sides. Back then there was pride in making something, and that is one of the reasons I like these old radios.
 Here are the photos you requested.. One is a before picture
 Glad you like it


Attached Files Image(s)
                   

   Living in Calgary Alberta


Messages In This Thread
Another RCA done - by Dan Walker - 08-05-2015, 11:25 PM
RE: Another RCA done - by OldRestorer - 08-06-2015, 09:12 AM
RE: Another RCA done - by Eric Adams - 08-06-2015, 10:12 AM
RE: Another RCA done - by sam - 08-06-2015, 11:07 AM
RE: Another RCA done - by TA Forbes - 08-06-2015, 11:27 AM
RE: Another RCA done - by Dan Walker - 08-06-2015, 12:18 PM
RE: Another RCA done - by PhilcoJohn - 08-10-2015, 06:22 PM
RE: Another RCA done - by KCMike - 08-10-2015, 06:55 PM
RE: Another RCA done - by morzh - 08-11-2015, 10:51 AM



Users browsing this thread: 1 Guest(s)