|
Hickok 600A Calibration
10-25-2016, 11:55 AM
(04-13-2016, 01:38 PM)Steve McDonald Wrote: I don't use calibration tubes. I made a a 5mA. transformer I use as a current source. 5 mA. corresponds to 1000 mhos on your meter. The most important part of calibration is to make sure the tested tubes are tested at the proper voltage. This is a good calibration procedure (too).
« Next Oldest | Next Newest »
Messages In This Thread
Hickok 600A Calibration - by etech - 01-12-2016, 05:13 PM
RE: Hickok 600A Calibration - by etech - 01-18-2016, 12:21 PM
RE: Hickok 600A Calibration - by Eliot Ness - 01-18-2016, 01:48 PM
RE: Hickok 600A Calibration - by etech - 01-18-2016, 05:46 PM
RE: Hickok 600A Calibration - by Eliot Ness - 01-18-2016, 07:20 PM
RE: Hickok 600A Calibration - by morzh - 01-18-2016, 08:02 PM
RE: Hickok 600A Calibration - by codefox1 - 01-19-2016, 12:36 PM
RE: Hickok 600A Calibration - by etech - 01-19-2016, 05:48 PM
RE: Hickok 600A Calibration - by TA Forbes - 02-15-2016, 03:35 PM
RE: Hickok 600A Calibration - by keith49vj3 - 03-26-2016, 08:50 AM
RE: Hickok 600A Calibration - by morzh - 03-26-2016, 11:45 AM
RE: Hickok 600A Calibration - by TV MAN - 03-29-2016, 08:51 AM
RE: Hickok 600A Calibration - by Steve McDonald - 04-13-2016, 01:38 PM
RE: Hickok 600A Calibration - by Phlogiston - 10-25-2016, 11:55 AM
RE: Hickok 600A Calibration - by Phlogiston - 10-25-2016, 11:51 AM
Users browsing this thread: 1 Guest(s) |
