04-08-2016, 12:27 PM
I am about to start work on a model 95 that I bought last year at K-town. There are a few 'dual-component' items in this chassis. One of these is item #10 which is a .05 cap and a 250 ohm resistor. These are not in Bakelite holders, but are in what appear to be cardboard tubes about 0.5" diameter and 1 or 1.5 inches long. I've never worked with a set that was quite this old.
Can these be re-stuffed? Are there any tricks to getting the original contents out without destroying the outer shell? Also, these seem to fastened to the chassis with a tab and a screw. Am I right in assuming that there is an electrical connection to this tab (and therefore to the chassis)?
Thanks,
Can these be re-stuffed? Are there any tricks to getting the original contents out without destroying the outer shell? Also, these seem to fastened to the chassis with a tab and a screw. Am I right in assuming that there is an electrical connection to this tab (and therefore to the chassis)?
Thanks,
