09-16-2016, 07:02 AM
Mine showed up yesterday and it looks good, not just thrown together. Even the ends of the handle are beveled. I could make one also, but that takes time and some trial and error. I don't mind paying a little for something that has already had that done, and I can just grab and use when needed. Mike is right about the fact this if not just for those trimmers with B+. Anyone here that has ever done an alignment with a metal nutdriver knows how much fun it is to try adjusting a padder and constantly having to guess where it is set, then remove the driver just to find it changes each time. Sure, you can do it this way - but why fight it when you don't need to?
PS: I mentioned this phorum to Tom and he seemed to indicate if there is enough interest that he would be willing to tool up and make another run of these.
PS: I mentioned this phorum to Tom and he seemed to indicate if there is enough interest that he would be willing to tool up and make another run of these.
If I could find the place called "Somewhere", I could find "Anything"
Tim
Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
