[ccomer1955]

The candohm is measuring at 50 ohms which is what the schematic calls for, but I've always heard that it is best to replace them while you're working in the chassis since they will go out sooner or later. Would a 5w 50 ohm sand resistor do?

Also, on the 40-40 electrolytics, will 250 volt caps be sufficient?

I've been replacing rubber coated wire, resistors, and wax caps today, but tomorrow I will head over to the electronics shop after work for the rest of the parts.

http://www.nostalgiaair.org/pagesbymodel...013479.pdf