04-10-2017, 11:14 PM
Question about the .5 UF 50 Volt caps..can they be replaced with 0ne .5 uf cap?
See schematic.. in previous posts
There are 2 terminals coming out on both sides. 2 are shorted together and grounded. Other 2 are not But when measuring from one to other its a short. but from either one to the shorted ones it measured .5 uf ..
why would they do this ?? seems like you could use just one cap..
Skip...
See schematic.. in previous posts
There are 2 terminals coming out on both sides. 2 are shorted together and grounded. Other 2 are not But when measuring from one to other its a short. but from either one to the shorted ones it measured .5 uf ..
why would they do this ?? seems like you could use just one cap..
Skip...
