Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

ID on this one tuber...?
#4

Very kwel!!! I would guess that it was a kit of some sort. It is regenerative, the knob one the left control the regeneration, center knob is the tuning and the the knob on the right adjust the filament voltage.
Not sure about the filament wiring as the pic doesn't show it well.


Attached Files Image(s)
   

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
ID on this one tuber...? - by klondike98 - 08-15-2017, 06:30 PM
RE: ID on this one tuber...? - by WallaceRoger - 08-15-2017, 07:06 PM
RE: ID on this one tuber...? - by Paul Philco322 - 08-15-2017, 08:48 PM
RE: ID on this one tuber...? - by Radioroslyn - 08-16-2017, 03:30 PM
RE: ID on this one tuber...? - by klondike98 - 08-17-2017, 12:03 AM
RE: ID on this one tuber...? - by Radioroslyn - 08-17-2017, 10:26 AM
RE: ID on this one tuber...? - by 462ron - 08-17-2017, 03:47 PM
RE: ID on this one tuber...? - by Arran - 08-17-2017, 05:34 PM
RE: ID on this one tuber...? - by Radioroslyn - 08-17-2017, 07:00 PM
RE: ID on this one tuber...? - by WallaceRoger - 08-17-2017, 07:35 PM
RE: ID on this one tuber...? - by klondike98 - 08-18-2017, 11:13 AM
RE: ID on this one tuber...? - by palegreenthumb - 08-18-2017, 10:39 PM



Users browsing this thread: 1 Guest(s)