Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-630....middle of the road set?
#29

Good reminders, Ron. No telling how many cabinets have lost edge veneer due to the sliding out of the delivery vehicle. On top of that most beginners would just throw those edge slivers into the trash, when they can be glued back on again.....

The '36 & '37-116's are some of my favorite Philco consoles. Had a beautiful 38-116 years ago and let it go by mistake. Now I would prefer the '36 & '37's.


Messages In This Thread
37-630....middle of the road set? - by dal61 - 10-01-2017, 12:54 PM
RE: 37-630....middle of the road set? - by dal61 - 10-01-2017, 03:38 PM
RE: 37-630....middle of the road set? - by dal61 - 10-01-2017, 07:59 PM
RE: 37-630....middle of the road set? - by dal61 - 10-01-2017, 10:30 PM
RE: 37-630....middle of the road set? - by dal61 - 10-02-2017, 06:24 AM
RE: 37-630....middle of the road set? - by dal61 - 10-02-2017, 09:43 PM
RE: 37-630....middle of the road set? - by morzh - 10-02-2017, 09:54 PM
RE: 37-630....middle of the road set? - by dal61 - 10-02-2017, 10:29 PM
RE: 37-630....middle of the road set? - by SteveG - 10-02-2017, 10:40 PM
RE: 37-630....middle of the road set? - by dal61 - 10-03-2017, 06:34 AM
RE: 37-630....middle of the road set? - by dal61 - 10-03-2017, 11:32 AM
RE: 37-630....middle of the road set? - by morzh - 10-03-2017, 12:17 PM
RE: 37-630....middle of the road set? - by dal61 - 10-03-2017, 04:03 PM
RE: 37-630....middle of the road set? - by morzh - 10-03-2017, 04:08 PM
RE: 37-630....middle of the road set? - by dal61 - 10-03-2017, 07:20 PM
RE: 37-630....middle of the road set? - by Arran - 10-03-2017, 09:25 PM
RE: 37-630....middle of the road set? - by dal61 - 10-05-2017, 12:15 PM
RE: 37-630....middle of the road set? - by SteveG - 10-05-2017, 02:32 PM
RE: 37-630....middle of the road set? - by dal61 - 10-08-2017, 02:25 PM
RE: 37-630....middle of the road set? - by dal61 - 10-08-2017, 06:24 PM
RE: 37-630....middle of the road set? - by dal61 - 10-09-2017, 09:18 PM



Users browsing this thread: 1 Guest(s)