09-17-2018, 08:35 PM
So I was looking over my 6T2 cabinet this evening.
I think it looks pretty darned good for an amateur refinish. The gloss lacquer gives it a nice, deep shine.
And the run on the right side...really isn't that noticeable. I've seen minor runs like this on original finishes (rarely, mind you, but I have seen them a time or two).
I said all that to say this:
I hereby declare the 6T2 cabinet to be...DONE.
I think it's pointless to keep nit-picking when it looks pretty good now. (Besides, I might mess it up again trying to correct the run 
so I think I really should leave well enough alone.)
So as I said previously...with God's will, my first project after surgery and recuperation will be to rebuild the chassis of this 6T2. This thread will resume at that time. For now, though...back to the Philco 66B, RCA T7-5, Philco 41-KR, etc. ...whatever I can accomplish before surgery (and I still do not know when that will be).
I think it looks pretty darned good for an amateur refinish. The gloss lacquer gives it a nice, deep shine.
And the run on the right side...really isn't that noticeable. I've seen minor runs like this on original finishes (rarely, mind you, but I have seen them a time or two).
I said all that to say this:
I hereby declare the 6T2 cabinet to be...DONE.
I think it's pointless to keep nit-picking when it looks pretty good now. (Besides, I might mess it up again trying to correct the run so I think I really should leave well enough alone.)So as I said previously...with God's will, my first project after surgery and recuperation will be to rebuild the chassis of this 6T2. This thread will resume at that time. For now, though...back to the Philco 66B, RCA T7-5, Philco 41-KR, etc. ...whatever I can accomplish before surgery (and I still do not know when that will be).
--
Ron Ramirez
Ferdinand IN
