Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Identifying a Model 16 console chassis.....
#1

I know....sounds weird doesn't it?

The above radio was given to me or it would've had a date with a landfill if I didn't take it. The label says "16" but the chassis has yet to be found in my Rider books. I emailed Chuck Schwark and I'm awaiting a reply from him. But I figured I'd throw it out to the mavens on this site and possibly get a few answers...

This circuit is very similiar to the first 16 shown in Nastalgia Air here....

http://www.nostalgiaair.org/pagesbymodel...013139.pdf

With the exception of part 75 e-cap (which was never present on my chassis and the value is not known) and that the two other e-caps (87 and 88) in the lower right hand corner of the chassis are a bit different also. One e-cap (87) seems correct but the other (88) is a two-section cap in my chassis but is notated as a one section ecap on the print. 

In another print, Model 16 Code 125 and 126, part number 91 is shown as a 2 section cap while 98 is shown as a single cap. The non existant ecap on my chassis (75) in the earlier print is now notated as part 73 and is a 4 section cap. See here....

http://www.nostalgiaair.org/pagesbymodel...013141.pdf

I hope I've explained this well enough. I doubt if there is no print for this particular chassis it's just that I haven't found it yet. And yes, the radio works very well on all bands but the power supply, as it exists now, is slowly shorting out. (typical) 13 Boats to restore....this one's gonna take a while.

Thanks for the input....
Jim Koehler

Good luck with the project and all of us here are expecting a full report when you're finished.


Messages In This Thread
Identifying a Model 16 console chassis..... - by Jim Koehler - 08-24-2018, 09:02 AM



Users browsing this thread: 1 Guest(s)